05:53
Faizan
Icom transceivers have memory channels used to store radio frequencies and the associated repeater information. The operating frequency, the duplex direction with an offset frequency, the sub-audible tone encoder, the tone squelch (and other tones) and skip information can all be programmed into a memory channel. You’ll need to get the required information from your repeater operator or radio club before starting the programming.
Step 1
Push the "VFO" (Variable Frequency Oscillator) button. This button will change the frequency.
Step 2
Set the frequency you want to store. At the same time, you will set the other data-like repeater information. Press "H/L/Set" for one second and the radio will enter set mode. Press “Tone” repeatedly until “rT” appears, then rotate the dial to select the sub-audible tone you need. Push "VFO/Clear" to exit the set mode.
Step 3
Press “Tone” again until “OW” appears and rotate the dial to the required offset. Press “VFO/Clear” to exit.
Step 4
Verify that the frequency you want is still on the screen and press “S.MW” for a brief moment. “MR” should flash on the display.
Step 5
Rotate the dial to the channel you want to use to store the frequency and its associated repeater data.
Step 6
Press “S.MW” for one second to program the radio. “MR” will stop flashing and the frequency will be programmed at the channel you chose.
Step 1
Push the "VFO" (Variable Frequency Oscillator) button. This button will change the frequency.
Step 2
Set the frequency you want to store. At the same time, you will set the other data-like repeater information. Press "H/L/Set" for one second and the radio will enter set mode. Press “Tone” repeatedly until “rT” appears, then rotate the dial to select the sub-audible tone you need. Push "VFO/Clear" to exit the set mode.
Step 3
Press “Tone” again until “OW” appears and rotate the dial to the required offset. Press “VFO/Clear” to exit.
Step 4
Verify that the frequency you want is still on the screen and press “S.MW” for a brief moment. “MR” should flash on the display.
Step 5
Rotate the dial to the channel you want to use to store the frequency and its associated repeater data.
Step 6
Press “S.MW” for one second to program the radio. “MR” will stop flashing and the frequency will be programmed at the channel you chose.
Posted in: electronics
